VX1000 - Scalable Measurement and Calibration Hardware

Scalable ECU Interfaces for Maximum Data Transfer Rates

What is VX1000?

The VX1000 System is a scalable solution with top performance for your measurement and calibration tasks. It can be used in the vehicle – both in the interior and in the engine compartment – on test benches and in the laboratory. The system forms the interface between the ECU and a measurement and calibration tool such as CANape. For high data throughput with minimal impact on ECU run-time, data is accessed over the microcontroller-specific data trace and debug ports.

Overview of Advantages

  • Powerful measurement and calibration access to internal ECU data with maximum transmission rates
  • Very small POD to connect to the ECU debug interface
  • Easy and quick integration into the ECU software
  • No impact on ECU run-time with data trace measurement method
  • Interface to numerous development tools by third-party suppliers


  • Very high measurement data throughput of more than 100 MByte/s for XCP data and radar raw data
  • Measurement of fast signal cycles (up to 10 µs for data trace, up to 40 µs for copying method)
  • Measurement configurations with over 100,000 signals
  • Precise generation of DAQ time stamps in the ECU
  • ECU cold start measurement (First Loop DAQ)

Supported Microcontrollers

  • Infineon: TriCore TC1xxx, TriCore AURIX TC2xx & TC3xx, XC2000 Family
  • NXP / STM: PowerPC xPC5xxx and PowerPC MPC57xx
  • Renesas: RH850 and V850E2
  • Texas Instruments: TMS570
Did you find this page helpful?

Please comment: